This system is ideal for smaller applications such as offices, homes, small factories
and warehouses.
All CAE500 Repeater Systems come with all
you need to get the system working.
Parts include:
High Gain FCC licensed In-Building
Amplifier
7 dB Yagi Directional Antenna (Panel
antenna for PCS)
Ceiling Mounted Omni Directional
Antennas
Broadband Power Combiner (CAE500-2
and CAE500-3 ONLY)
50 ' Low loss LMR400 type cables with connectors already attached
for easy installation. This connects from
amplifier to outdoor (yagi or panel) antenna
Power Supply for the Amplifier
Connect together the system as follows:
Typical Installation
Instructions
1. Install Exterior
Antenna on Roof
2. Install Amplifier inside at convenient location. Make sure 120V
available to connect power transformer (do not power up)
3. Run cable from outdoor Antenna to Amplifier
4. Connect Power Divider with 3' cable to Amplifier (CAE500-2
and CAE500-3 ONLY)
5. Locate the Internal Antenna install on ceiling (or wall) and connect
cable from antenna to Amplifier (CAE500-1 ONLY)
6. Check all cables and power up amplifier
7. Rotate Yagi until maximum signal strength on phone inside the
building in the area covered by the internal antennas is achieved.
Tri-Band Fiberglass Omni Antenna Freq.- 824-960/1710-2170
$99.95
CA300-NLP
CA300-NLP
Surge Filter/ Lightning Protector Best for RF Performance indoor - outdoor use single strike
economical lightning protector. Can handle 300 watts of
transmission power. Covers 700 MHz - 2.7 GHz range. Gives protection
against a 20kA surge
$49.95
CA-MAST
CA-MAST
Universal J-Pipe mount
used for mounting our roof
mount Yagi and Panel antennas.
This mount is designed to
fit on the side of a house. Either end of the mast can be attached to
the base, depending on how much clearance is required for the antenna.
Note: Lag bolts not supplied.
Not
recommended for antennas with a boom length longer than 40"
Dimensions - 42 x 6 x 6
